Bin Washing Line and Storage system
FoodMeat

Bin Washing Line and Storage system

Automated washing, storage and on-demand delivery system for 200-litre stainless-steel bins. A tunnel washing line cleans 100 bins per hour, a buffer storage holds around 400 clean bins, and production calls them out at up to 200 bins per hour. The whole line was tested as a 3D simulation before installation.

Location
Finland
Completed
November 2023
Manufacturing Time
12 months

Key features

  • Washing capacity 100 bins/h
  • Storage capacity 400 bins
  • Delivery to production 200 bins/h
  • Virtual commissioning with 3D simulation

This complete solution washes, stores and delivers 200-litre stainless-steel bins in a demanding food-industry environment. Dirty bins go in at one end, and clean bins arrive in production on request, upright and ready to use, with no manual handling in between.

Infeed and turning

The automated infeed handles three bins at a time and moves them by conveyor to the bin turning device, which turns each bin upside down for washing. The system accommodates design variations, such as the absence of a central axle in certain bin models, ensuring reliable handling.

Tunnel washing

The three-stage tunnel washing line (pre-wash, main wash and rinse) cleans 100 bins per hour. The washing technology is based on the proven system used in our crate washers.

  • Drum filters
  • Mesh screens
  • Low-profile stainless-steel chain with lugs for secure positioning
  • Adjustable temperatures for each stage (+35–65 °C)
  • Water consumption optimized to 3–5 litres per bin
  • Detergent dosing system

RFID identification and transfer to storage

After washing, bins pass an RFID reading station that identifies each bin and directs rejected units to the reject conveyor. Accepted bins are raised by a lift to an overhead conveyor that carries them to the storage above floor level, leaving the floor below free for passage.

Buffer storage

Clean bins are kept upside down in a buffer storage for 408 bins on five levels. Bins enter from the top, and the storage has step-operated conveyors, a belt-driven transfer carriage and individual cell emptying. In normal operation every washed bin goes to the storage, so washing and production do not have to run at the same pace.

Delivery to production

Production calls bins at the push of a button. The transfer carriage collects a bin from its lane, an outfeed lift lowers it, and a second turning device sets it upright on its wheels before it travels through the wall into the production area. The storage can deliver up to 200 bins per hour, twice the washing rate, which covers peaks in demand. If the storage is being serviced, washed bins can be routed directly to production.

Controls and virtual commissioning

The system is controlled by a Siemens control and monitoring platform (WinCC Unified), which gives real-time monitoring of alarms, statuses and measurement values, and a Siemens mobile panel with four connection points allows safe and flexible operation.

Before installation the whole line was commissioned virtually: the control program was run against a 3D simulation of the machinery, so the sequences were tested and corrected before anything was installed on site.

Safety

  • Motors and gearboxes protected against oil and water leaks
  • Hoist mechanisms secured against sudden drops
  • Safety fencing and service platforms
  • Manual turning device for bins with damaged RFID tags

The complete setup combines high throughput, long service life and reliable operation, improving production efficiency and reducing manual handling.

Images

Interested?

Contact us and tell us about your needs. We'll tailor a solution that meets your requirements.

Contact Us